Call now: 207-809-9099

Sullivan County, NH · 129 mi from our Brunswick shop

Furnace & boiler repair in Acworth, NH

From a furnace that won't ignite to a boiler that keeps locking out, we diagnose and repair heating problems in Acworth and nearby.

What we do

  • No-heat diagnosis and repair
  • Furnace repair and replacement (gas & propane)
  • Hot-water and steam boiler service
  • Ignition, flame sensor, igniter and control board repairs
  • Thermostat installation and smart thermostats
  • Annual heating tune-ups and safety checks

Signs it's time to call

  • No heat, or some rooms stay cold
  • Furnace short-cycles on and off
  • Banging, whistling or burning smell
  • Pilot or ignition won't stay lit
  • Boiler pressure keeps dropping

Older New England homes often have oil or propane boilers that can be paired with a heat pump instead of being replaced outright — we'll look at what you have in Acworth and give you both options.

Acworth, New Hampshire is served on scheduled service trips from our Brunswick shop (about 175 minutes away). Installs, tune-ups and planned repairs are grouped by area — call or book online and we'll give you the next available date. All towns in Sullivan County, NH →

Common questions

My heat went out at night — can you come now?+

Yes. Call 207-809-9099 any time. In freezing weather, no-heat calls are our first priority.

Repair or replace?+

We'll tell you honestly. If the repair is reasonable for the system's age, we repair it. If not, we show you replacement options — including heat pumps.

Can I run my heating system on a generator during an outage?+

Most furnaces, boilers and pumps can run on a properly sized generator connected through a transfer switch or inlet installed by an electrician. Never back-feed through a dryer outlet, and never run a generator in a garage or near windows.

How often should my heating system get a tune-up?+

Once a year, ideally in late summer or early fall before the first cold night. Oil systems especially benefit from an annual cleaning and nozzle/filter change. Heat pumps should be cleaned yearly too.

How often should I change my filter?+

Check furnace filters monthly in heating season and replace when dirty — typically every 1–3 months. Mini-split indoor filters rinse clean; do them every few weeks when the system runs hard, more often with pets.

How can I lower my heating bills?+

Seal air leaks and add insulation where it's thin, keep filters and coils clean, use steady thermostat settings with a heat pump, and service fuel-burning equipment yearly. For many oil-heated homes, adding a heat pump is the biggest single cut.

Open 24/7 for emergencies

Need a technician?

Call now for emergencies, or pick a time online — we'll confirm by phone or text.

📞 CALL NOW · 207-809-909924/7 EMERGENCY SERVICEHEATING · COOLING · REFRIGERATION📞 CALL NOW · 207-809-909924/7 EMERGENCY SERVICEHEATING · COOLING · REFRIGERATION📞 CALL NOW · 207-809-909924/7 EMERGENCY SERVICEHEATING · COOLING · REFRIGERATION📞 CALL NOW · 207-809-909924/7 EMERGENCY SERVICEHEATING · COOLING · REFRIGERATION📞 CALL NOW · 207-809-909924/7 EMERGENCY SERVICEHEATING · COOLING · REFRIGERATION📞 CALL NOW · 207-809-909924/7 EMERGENCY SERVICEHEATING · COOLING · REFRIGERATION